Answer of your leaving message
The camera doesn't boot properly. I can't even reset it. I'd like to upgrade manually the firmware to reset up afteward. The following Dropbox link doesn't work :
Do you have another where I can get the latest firmware?

Thank you
Best regards,
Ayhan Sahin

by Sahin

Dear Ayhan, thank you for contacting.

Here is the link for you. Please take steps to make it. Thank you

1. Please check/exchange the AC and USB cable to cross check.
2. Please check/format the SD health by this tool /

Rebuild the firmware from the external SD card :
This is a manual re-build firmware procedure for your reference (recovery and cure rate is more than 90% )
Download file :
ICAM PRO (ATOM) series : [ to PC ]

- Uncompress/unzip it to ROOT directory of a Micro SD card [ PC->SD ] (1 file and 1 folder)
- Insert the card to the camera
- Plug power cord of it. CAM will auto detect the codes in the Card to do the update ( blue light is on )

D. Auto motor calibration/rotation (About 40~50 seconds)
- Wait till front blue led is blinking. (About 2-3 minutes)
- Unplug power cord
- Take card out.
- Plug power cord again and the blue led will keep blink ( waiting for installation )

Installation: / If you are successful, please erase the card for normal use.

PS this is what you see during the process
Insert the card with unzipped files
Plug in power Short beep ( camera detect and read the files ) in 5 seconds
After about 40 seconds Two short beeps ( writing complete )
Blue and Green lights blinking – done ( wrote in )
Unplug the power
Remove the SD and erase it for future use