Answer of your leaving message
my iBaby HD camera looks faulty, the LED lights up but it can not be connected even after reset. Probably the RAM memory is full. How to delete/clear RAM and reload the current firmware?

2018-08-22 10:19:25****************************************
everything is done according to instructions ..., CAM do not detect the codes in the Card, only blue light is all the time on, according to me there is full a RAM memory to cam,
how to reset the camera memory?

2018-08-22 10:40:47****************************************
it helped me the method,
detect the codes in the SD Card took very long time of about 8 minutes...
Thanks

by Tomas


Dear Tomas, thank you for the mail.
If the camera does not response to the hardware reset, you may try the method below.

A. Please must use this tool to format the SD card on PC
https://www.sdcard.org/downloads/formatter_4/index.html

Rebuild the firmware from the external SD card :
This is a manual re-build firmware procedure for your reference
(recovery and cure rate is more than 90%)

Download file
https://www.dropbox.com/s/mzj48a2o2hafm5h/iCam_iBabi_v3716.rar?dl=0

- Uncompress/unzip it to ROOT directory of a MicroSD card [PC->SD] ( one folder and one file )
- Insert the card to the camera
- Plug power cord of it. CAM will auto detect the codes in the Card (a beep)
to do the update ( blue light is on )
- Wait till front blue and green leds are blinking. (About 1 minute)
- Unplug power cord
- Take card out.
- Plug power cord again and the blue led will keep blink ( waiting for installation )

Installation: https://www.youtube.com/watch?v=V-j_OzXsANo , If you are successful, please erase the card for normal use.

PS – this is what you see during the process

Insert the card with unzipped files
Plug in power
Short beep ( camera detect and read the files ) in 5 seconds
After about 40 seconds
Two short beeps ( writing complete )
Blue and Green lights blinking – done ( wrote in )
Unplug the power
Remove the SD and erase it